Mechanical Gary Gecko Share this page: What you will need Bostik Coloured School Glue – Green Printed template (116.27 KB) Bostik Glu Dots Bostik Blu Stik Coloured cardboard Colouring pencils Scissors Paper straws Thread Instructions Step 1: Print Template Print out Gary Gecko template (above) and colour in Step 2: Cut Gary out Cut out Gary from the template Step 3: Segment the tail Cut Gary's tail into segments Step 4: Glue Gary Use Blu Stik to glue the pieces of Gary in position on new card, leaving a gap between the segments so they can bend Step 5: Cut out Gary again! Cut out Gary from the card you've attached him to. Step 6: Cut straw Cut and use School Glue PVA to stick small pieces of straw along the tail, and longer lengths of straw to run down the body Step 7: Thread straw Thread through the straws, leaving approx. 10cm hanging out the end, then tie a loop. Step 8: Secure the tail Cut the thread at the top of the tail and secure to the end of the tail with a Glu Dot Step 9: Make Gary move! Insert your finger in the loop and pull to make Gary move! Where to buy Bostik Coloured School Glue – Green Where to buy Related products GLU DOTS REMOVABLE Removable adhesive dots More details SCHOOL GLUE COLOURED Water-based PVA available in 4 colours More details Discover Create Products Product Finder See all products Share this page: